How to install the mobile phone jammer?
Nowadays, it is necessary to avoid the negative effects caused by the signals of some electronic devices, and cell phone jammers are installed in some special environments. In this way, the electronic device will not generate a signal or the signal will become weak, which can reduce the negative impact of the signal. How to install the device? It needs to be determined according to the installation location and area:
1. For single space
Like common small and medium-sized conference rooms, the interior is a transparent environment, the selection of the shielding point is relatively simple, and the number of points required is small.
2. 100-300 square meters
For a conference room with an area of about 100-300 square meters, generally installing 1-2 low-power units in it is basically enough to shield the entire conference room. The installation location is also arbitrary depending on the on-site environment. If there is a ceiling or a movable ceiling above the conference room, the signal jammer can be installed directly on the ceiling or ceiling. Or you can choose to install it on the conference table, in a corner or on the wall on a certain side of the venue. You can use the built-in omnidirectional antenna. If you want to reduce the impact on the outside world, you can replace it with a directional antenna.
3. More than 300 square meters
In a single space with an area of more than 300 square meters, the installation points of the shield can be selected according to the length and width of the site using an equidistant distribution method. The quantity is generally more than 3 units. As for the installation position, if it can be installed on the ceiling in the middle, it can achieve complete coverage with fewer points. Otherwise, use the installation method of hanging on the walls on both sides.
To facilitate a successful installation, the area of the installation site should be known before installing the shield. When installing, it must be determined according to its coverage and cannot be installed at will. in order to improve its shielding effect. Facilitates signal attenuation and masking.
Sample Image Gallery
