How to determine the installation point of mobile phone signal jammer?
It needs to be decided according to the installation location and area.
1. For single space
For the more common small and medium-sized conference rooms, the internal environment is relatively transparent, so the selection of the isolator points is relatively simple and the number of points required is relatively small.
2. 100-300 square meters
For a conference room of about 100-300 square meters, 1-2 low-power cell phone jammers are usually installed, which can basically meet the shielding effect of the entire conference room. In addition, the installation location must be determined according to the on-site environment. If there is a ceiling or a movable ceiling above the conference room, the jammer can be installed directly on the ceiling or ceiling. Or you can choose to install it on the conference table, corner or wall in the venue. You can also use the built-in omnidirectional antenna. If you want to reduce the impact on the outside world, you can install it as a directional antenna.
3. More than 300 square meters
For a single space of more than 300 square meters, the installation points of the shield can be selected according to the length and width of the site and the equidistant distribution method. The quantity is usually more than 3 units. If it can be installed on the middle ceiling, a relatively small number of points can be used to achieve complete coverage. Otherwise, use the wall-mounted installation method on both sides.
In order to install successfully, you need to know the area of the installation site before installing the shield. Moreover, when installing, you must make a decision based on its coverage, and never install it randomly. Correct installation can improve the shielding effect of the signal blocker and promote signal reduction and shielding.
Sample Image Gallery
