How to install the cell phone signal jammer?
It needs to be decided according to the installation location and area.
1. For single space
For the more common small and medium-sized conference rooms, the internal environment is relatively transparent, so the selection of the points of the shield is relatively simple, and the number of points required is relatively small.
2. 100-300 square meters
For a conference room of about 100-300 square meters, usually 1-2 low-power cell phone blocker are installed, which can basically meet the shielding effect of the entire conference room. In addition, the installation location should be determined according to the on-site environment. If the conference room is above the ceiling or has a movable ceiling, then the shield can be directly installed in the ceiling or ceiling. Or you can choose to install it in the conference table, corner or wall in the venue. You can also use the built-in omnidirectional antenna. If you want to reduce the impact on the outside world, you can install it as a directional antenna.
3. Above 300 square meters
For a single space of more than 300 square meters, the installation point of the shield can be selected by the method of equidistant distribution according to the length and width of the site. The number is usually more than 3 units. If it can be installed on the ceiling in the middle, this can achieve the effect of complete coverage with a relatively small number of points, otherwise, the installation method of hanging on the walls on both sides is used.
In order to be able to install successfully, you need to know the area of the installation site before installing the shield. Moreover, when installing, you must make a decision according to its coverage, and do not install it at will. Correct installation can improve the shielding effect of the shield and promote signal reduction and shielding.
Sample Image Gallery
