The EOD jammer is also known as the police jammer. The signal jammer is divided into two types, one is a trailer type and the other is a vehicle type. There are also differences in the use of the two types of EOD jammers.
Before using the tow box type EOD interference instrument, you need to confirm whether the built-in battery has electricity. It is best to charge the tow box type EOD interference instrument after the previous task is performed until the battery is fully charged. When performing the task, avoid the equipment not reaching the normal working time because the battery is not fully charged.
Before the box-type police jammer is turned on, it is necessary to match the antennas of the radio frequency modules of each frequency corresponding to the signal frequencies, and fully tighten them to avoid virtual connection, otherwise the police jammer module will not be able to output normally, resulting in module failure.
For the vehicle-mounted EOD jammer, before the police jammer module is powered on, the antenna on the roof needs to be raised. The EOD jammer uses an omnidirectional antenna, and the best effect can be achieved only when the antenna is perpendicular to the ground.
When the vehicle-mounted police jammer is not used for a long time, the power compensation battery needs to be charged from time to time. When charging the battery, it is only necessary to start the police jammer vehicle and turn on the power to generate electricity.