Mobile phone signal shielding system is also called mobile phone shielding system. This system adopts B/S architecture and can realize remote unified control and management through TCP/IP protocol. Each mobile phone signal shielding device has an independent IP address, just like ordinary network equipment. , connect the network cable to realize networking.
Through the mobile phone shielding system, the function of point-to-point switch, fully open and fully closed, and free group switch can be realized;
The mobile phone signal shielding system can also arrange the timing schedule and realize the function of timing switch.
The mobile phone shielding system can also realize the function of fault inquiry and fault alarm, which greatly saves the daily inspection work time.
The mobile phone shielding system can also remotely switch any channel of any mobile phone signal jammer, and can also remotely adjust the transmission power of any channel.
Then the mobile phone signal shielding system can only shield the mobile phone signal and not the WiFi signal? This function can be realized, and there are two ways to realize it.
The first one can be achieved by selecting a module without WiFi frequency band when assembling the mobile phone signal jammer, and avoiding the WiFi frequency band when adjusting the transmission frequency of the mobile phone wifi jammer, that is, not transmitting signals in the WiFi frequency band. Do not block the signal of the WiFi band.
The second is that the mobile phone shielding system has been installed and used normally. It is found that the WiFi signal is blocked and the WiFi device that needs to be connected cannot be used. In this case, you can use the mobile phone signal shielding system to adjust the transmit power of the WiFi module to the minimum or close it directly. The output of the WiFi module.
The mobile phone signal shielding system can not only adjust the transmit power of the WiFi module to the minimum or turn off the output of the WiFi module, but the mobile phone shielding system can adjust the transmit power of any frequency module of the jammer to the minimum or even close it.