The cell phone jammer uses the same downlink frequency of the mobile phone receiving base station to perform electromagnetic interference at the same frequency. The signal strength of the nearby base station will affect the mobile phone shielding effect. So how to test the mobile phone signal strength in the place where the mobile phone signal jammer is used?
School examinations are used to prevent students from using mobile phones to transmit information, leak test papers, cheat on exams, etc. Some are also used to prevent teachers from leaking test paper information while escorting test papers, which will have a negative impact on later exams.
The high school entrance examination and the college entrance examination are about to come in midsummer in June. In order to ensure the quality of the examination, many schools have started preparing examination rooms early. In the process of preparing for the examination room, one very important thing is to install a mobile phone signal jammer. However, installing a cell phone signal jammer is not something everyone can do. So, what should you pay attention to when installing a mobile phone signal jammer? In fact, the installation itself will be relatively simple, but a few small details before installation determine how effective the subsequent use of the signal blocker for cell phone will be. For example, the environment near the installation site. There is also the installation height.
In order to ensure the best signal effect, it is generally best to install it between one meter and three meters away. The mobile phone signal jammer is relatively small and can be fixed on the ceiling or wall with ordinary screws. Of course, it can also be used directly on a table or something like that. However, in this case, the effect is not very good. After installation, check whether everything is well connected and whether there are any problems with accessories such as the power supply.
Finally, plug the power adapter into the machine's adapter power socket and connect it directly to the 220V power supply. The next step is to test the machine. If there is a problem and it is discovered during the test run, you can contact the manufacturer as soon as possible. As long as it is produced by a regular manufacturer, it will usually be solved in time. If you encounter a defective manufacturer, it is still recommended to go to the manufacturer directly to return the product. So here, we recommend manufacturers like topsignaljammer. Not only is the reputation reliable, but the quality is also reliable. And any problems will be solved in time to ensure that the interests of customers are not harmed.