Selection of installation locations for wireless signal jammers in different areas of space
In order to obtain the required shielding effect, the number and installation location of wireless jammers need to be determined according to the installation environment and area. Before installation, you need to know the area of the installation site. When installing, make a decision based on device coverage and do not install at will.
1. For single space
For the more common small and medium-sized conference rooms, the internal environment is relatively transparent, so the selection of the points of the isolator is relatively simple, and the number of points required is relatively small.
2. 100-300 square meters
For a conference room of about 100-300 square meters, 1-2 low-power signal blockers are usually installed, which can basically meet the shielding effect of the entire conference room. In addition, the installation location must be determined according to the on-site environment. If there is a ceiling or a movable ceiling above the conference room, then it can be installed directly in the ceiling or suspended ceiling, or you can choose to install it in the conference table or inside the venue. In the corner or on the wall. You can also use the built-in omnidirectional antenna. If you want to reduce the impact on the outside world, you can install it as a directional antenna.
3. More than 300 square meters
For a single space of more than 300 square meters, the installation points of wireless signal jammers can be selected according to the length and width of the site using an equidistant distribution method. The number is usually more than 3 units. If it can be installed on the ceiling in the middle, it can use a relatively small number of points to achieve complete coverage. Otherwise, use the wall-mounting method on both sides.
Signal Blocker Image Gallery
